When it comes to home improvement projects, replacing a toilet may not be the most exciting task on your list. However, if your current toilet is outdated, leaking, or simply not functioning properly, it may be time to consider a replacement. The good news is that with the right information and tools, replacing a toilet can actually be a relatively easy DIY project.
The first step in replacing a toilet is choosing the right fit for your bathroom. There are several factors to consider when selecting a new toilet, including size, style, and flushing power. Toilets come in various shapes and sizes, so it’s important to measure the space where your new toilet will be installed to ensure a proper fit. Additionally, you’ll want to choose a style that complements the overall aesthetic of your bathroom.
Another important factor to consider when choosing a new toilet is flushing power. Low-flow toilets are becoming increasingly popular due to their water-saving capabilities. These toilets use less water per flush than traditional models without sacrificing performance. When shopping for a new toilet, look for one with an efficient flushing system that meets EPA WaterSense standards.
Once you’ve selected the right toilet for your bathroom, it’s time to read more articles install it. Before getting started, make sure you have all of the necessary tools and materials on hand. You’ll need an adjustable wrench, screwdriver, wax ring kit (which includes bolts and gaskets), and possibly caulk or sealant.
To begin the installation process, shut off the water supply to the existing toilet by turning off the valve located behind the base of the unit. Next, remove any remaining water from the tank and bowl by flushing multiple times until empty. Disconnect the water supply line from both ends using an adjustable wrench.
With all connections disconnected and water drained from the old unit , carefully lift up on either side of its base while pulling upwards until completely removed . Place old unit aside then proceed with cleaning area where previous fixture was located before proceeding further .
Next , place wax ring onto flange then align bolt holes on bottom side of new fixture over holes in floor . Lower down into position ensuring that no part touches wall behind as this could cause damage later down line once fully seated . Tighten nuts onto bolts using wrench but avoid overtightening which might crack porcelain material used during manufacturing process .
Finally , reconnect water supply line followed by turning back valve releasing flow again throughout system before testing out newly installed device making sure everything works correctly first try without leaks present anywhere else around base nor underneath near connection points between parts themselves too !